|
Used equipment list as of June 9, 2011
HD-19 Hybrid Phone Patch - serviced/tested - excellent condition $25.00
QF-1 Q multiplier. For increased selectivity and reception capability of receivers which utilize a 455 khz IF frequency. From the 1962 Heathkit catalog - “Provides an effective “Q” of 4,000 for peaking or rejecting a signal on AM, CW, or SSB. Produces a sharply peaked I.F. curve for CW reception, broad peaked I.F. for phone operation or a deep rejection notch to eliminate a closely interferring heterodyne. Both peak or notch positions are tuneable to any point in the receivers I.F. bandpass.” The unit is in excellent condition. $25.00
SB-100 HF SSB/CW transceiver. Full 100+ watts output on 80 through
15 meters and 80 watts output on 10 meters. Receiver sensitivity
is excellent at less than .35 uv for 10db S+N/N ratio. Looks
good cosmetically and is ready to play! $325.00 SOLD
SB-301/SB-401 HF SSB/CW receiver/transmitter combination allows
split frequency and separate or transceive operation. These units
have been fully reconditioned and are operating to full 100+ watts
output on transmit (80 watts on 10 meters) and receive sensitivity
is excellent at .3 uv or less for 10 db S+N/N ratio on all bands.
This equipment is supplied with all connecting cables for
transceiver operation -- can also be operated as separate
transmitter and receiver. $450.00 SOLD
HW-101 80-10 meter SSB/CW transceiver. The unit has been reconditioned,
aligned, and calibrated. Output is 100 watts plus on 80-15 meters and
about 90 watts on 10 meters. The receive sensitivity is excellent
(less than .35 uv for 10 db S+N/N). The unit includes the optional CW
filter. $295.00
HM-102 Wattmeter/SWR Bridge. SWR Bridge with adjustable sensitivity.
Remote detector permits placement of meter in any location.
Cable supplied. The meter will operate on the HF frequencies from
1.8 to 30 MHz with a wattmeter accuracy of +/- 10% of full scale. Two
power ranges, 0-200 watts and 0-2000 watts. Impedance is 50 ohms.
Connectors are UHF type SO-239. The unit has been checked, aligned,
and calibrated. $55.00
HS-1661 Speaker. Station speaker contains a 4 ohm 5 X 7 oval speaker and
works well with the Heathkit ham gear. $45.00
HW-5400 Synthesized HF SSB/CW Transceiver. Covers 80 - 10 meters including
the WARC bands. Power output is 100 watts, 80 watts on 10 meters.
Receiver sensitivity is less than .35 uv for 10 db S+N/N. Includes the
HWA-5400-3 frequency entry keypad. The unit has been reconditioned for
proper operation and is working well. $395.00
HWA-5400-1 Speaker/Power supply. This is the speaker/power supply
unit designed to match the HW-5400 transceiver. The unit contains
a digital clock which can be set for 12 or 24 hour format. Output
is 13.8 VDC. The unit has been reconditioned and checked for proper
operation. Output is 13.8 VDC $175.00
SB-200 1KW Linear Amplifier. Covers 80 - 10 meters. The unit delivers
1200 watts PEP input, 1KW on CW with 100 watts drive. The unit has been
fully reconditioned and checked for proper operation. Output power
measured at 700 watts on 80 meters operating on 120 VAC with 100 watts
drive. The unit can be wired for 220 VAC operation which will produce a
bit more power. $525.00
HW-9 QRP Transceiver compact 80 - 10 meter HF CW transceiver. The unit
is in excellent condition. Completely checked, aligned, and calibrated.
The accessory WARC bandpack is included, installed, and aligned. Output is
adjustable from 0 to greater than 4 watts (8 watts on 80 meters) on all
bands. Receiver sensitivity is excellent at less than .2 uv for a readable
signal. Excellent selectivity with wide/narrow audio filter. The unit has
been reconditioned and is ready to operate. $375.00
HM-9 QRP Wattmeter. This is the low power wattmeter/SWR bridge designed to
match the HW-9 QRP transceiver. The unit has two power ranges, 0-5 watts
and 0-50 watts. Reads SWR from 1.1:1 to 3:1. This unit has been wired for
the 1.8 - 30 MHz range, can be wired for 50-54 or 144-148 MHz by changing a
few components (not available from us). The unit is in good shape and has
been checked for proper operation. $65.00
HFT-9-B 100 Watt Antenna Tuner provides matching to a wide range of output
impedances with a built-in 4:1 ferrite balun. Includes connectors for
coaxial feed, balanced line and long-wire antennas. Allows matching
capability between 1.8 and 30 MHz. An excellent match for the HW-9 QRP
station. It's small size also makes it useful for HF mobile operation.
$65.00
|